Chiltern Connection Products
Order Code: ITY-001153
QtyEx. VAT
1+£3.47
+-

Description

  • Prior Vermason Item Number: BB4DF
  • Gives “Faraday Cage”
    Protection against electrostatic discharges
  • Rs: 1 x 104 to < 1 x 109 ohms
    Inside and out
  • Static Shielding <25 nJ per EN61340-5-1 ANSI/ESD S11.31
  • Good see-through clarity
  • Heat sealable

Available with low charging antistatic high visibility yellow reclosable zipper

  • To see the Statshield Metal In bags being used at a workstation, click here
  • Sold 100 per pack

 

Sold in packages of 100 bags packaged in a protective oversized ESD bag

Resistance of outer surface: <1011 ohms per EN 61340-5-1 Test Method A.4
Resistance of inner surface: <1011 ohms per EN 61340-5-1 Test Method A.4
Thickness: Nominal .0030"" (.0762mm) ±10%

Technical Requirements and Guidance


“ESD protective packaging … when required, shall be defined for all material movement within protected areas, between protected areas, between job sites, field service operations and to the customer.”
Per Table 4, static dissipative packaging required range is 1 x 105 to less than 1 x 1011 ohms, conductive required range is 1 x 102 to less than 1 x 105 ohms, insulator is equal or greater than 1 x 1011 ohms tested per IEC 61340-2-3. Bag discharge shielding required range is less than 50 nanojoules tested per ANSI/ESD S11.31. [EN 61340-5-1 Edition 1.0 2007-08 clause 5.3.4 Packaging and Table 4]

Recommend closings bags with ESD susceptibility labels.
Per EOS/ESD S8 paragragh 3.1 ESD Susceptibility Symbol Application ""The Symbol may be incorporated on a sticker used to close or seal ESD protective packaging to indicate that materials inside the package are ESD susceptible."" For labels, Click Here
Desco Europe’s bags are recyclable
Mixed unsortable plastic scrap shall contain assorted plastics of multiple grades that are co-extruded, bonded or laminated together which are unsortable into individual grades.
Desco Europe ESD Bags Are Generally Reusable
For best results, bag inventory should be continually replenished. It is recommended that standard packs of bags should be stored in its original packaging in a climate controlled environment where the temperature ranges from 45 degrees F to 70 degrees F and relative humidity is 50%. Bags should not be stored in ultraviolet sunlight, moisture, or heat because the aluminum shielding layer could oxidize if exposed to these conditions.

We have no reports of degradation of ESD control properties of bags sealed in original standard pack packaging. Desco Europe's Limited Warranty expressly warrants that for a period of one (1) year from the date of purchase, Desco Europe products will be free of defects in material (parts) and workmanship (labor). Before using and after one year from purchase date, users shall determine the suitability of the Statshield ESD Bags for their intended use. Users assume all risk and liability whatsoever in connection therewith. Mishandling or improper storage may render an ESD Bag unusable to perform its function. ESD Bags that are ripped, torn, or scratched should be discarded.

From ANSI/ESD S20.20 section 6.2.4.2. Packaging Guidance: ""The objective of ESD protective packaging is to prevent a direct electrostatic discharge to the ESDS item contained within and allow for dissipation of charge from the exterior surface. In addition, the packaging should minimize charging of the ESDS item in response to an external electrostatic field and triboelectrification. They may also lose static shielding properties by crumpling, puncturing and folding.""

Some end users reuse a Statshield® Transparent Metal In ESD Shielding Bag up to six times and then discard.

Ideally, the user should test, auditing some percentage of the re-used ESD Bags using test procedures outlined in ANSI/ESD-STM11.11 Surface Resistance Standard, ANSI/ESD-STM11.12 Volume Resistance Measurements of Static Dissipative Planar Materials, and Shielding Materials ANIS/ESD STM11.31.

Desco Europe's only obligation shall be to replace such quantity of the product proved to be defective. See full Limited Warranty information.""Packaging, when required, shall be defined for all material movement within protected areas, between protected areas, between job sites, field service operations and to the customer."" See EN 61340-5-1 clause 5.3.4.

Statshield® bags are packaged 100 per package in an oversized shielding bag rather than a cardboard box. Therefore, our bags are not exposed to water vapors that will degrade the metallized shielding layer. Our bags have an additional layer of barrier protection because of our packaging.

 

Closeout items are subject to a 90-day warranty for materials and workmanship. No credit will be issued. Desco Europe to approve exchange for similar items.

Downloadables

Brochures

Logo 

Manufacturer: Desco Europe

MPN: 201015

Need Help?

Do you need product exported outside of the UK? 
Or need help with product selection?

Click here to complete our enquiry form and a member of our technical team will be more than happy to help.

Enquiries

Or talk to us today on Live Chat below.

Payment Options

Payment can be made online by debit/credit card or you can request a pro-forma invoice to pay by BACS. (Please note, there are no card fees for online transactions).

If you would like to open a 30 Day Credit Account, complete our Credit Account Form here

On approval of your account, our accounts team will provide you with all the information you require to place your orders.